Switching Off The M260Se Handheld Terminal; Status Of The Ds260 Docking Station Leds - ACD SetM260SEHF Manual Del Usuario

3.2.7 Switching off the M260SE Handheld Terminal

The device is switched off by pressing the three buttons "C"-, "↓" and "orange enter" right of the "0", whereby
the "0" button must first be pressed and held. Then also press and hold the "↓" button. Then also press and
hold the "orange enter" button. Press and hold these three buttons for at least 10 seconds.
Figure 8: Switching off the M260SE

3.2.8 Status of the DS260 Docking Station LEDs

The DS260 status LEDs are located on the front of the docking station.
Figure 9: Status of the DS260 LEDs
The POWER LED shows a faint green light as soon as the DS260 is supplied with current.
The light on the POWER LED will become brighter once a M260SE handheld terminal has been inserted into
the DS260 as the DS260 is then no longer in standby mode.
The CHARGE LED shows a red light when the M260SE is charging. The LED shows a green light once the
M260SE is charged. The temperature range for charging the M260SE battery is between 0 °C and 45 °C.
A temperature sensor is integrated in the DS260.
Any attempt to charge outside of this range will be prevented and the CHARGE LED will flash red.
The CONNECT LED has no function in the DS260 Standard version.
Unintended use of the interfaces should be avoided.
ATTENTION
M260SE_Brief_Overview_FCC_PEPPERL+FUCHS_V1.03_en_es.docx 11 / 28