Memory; Auto Tuning Storage (Ats); Recall The Stored Frequency - Sunstech RP-DS30 Manual De Funcionamiento

RADIO OPERATION

MEMORY

Manual Storing Station
1. Select the band.
2. Tune in a station.
3. Shortly press < > with the memory icon "E" flashes.
press shortly
4. Press < > or < > shortly to select the stored address.
press shortly
5. Press < > shortly to store the staion into memory. If
you don't want to save, press any key to exit.
NOTE:
FM band: can save 100 (00 ~ 99) frequencies;
MW band: can save 25 (00 ~ 24) frequencies;
SW band: can save 100 (00 ~ 99) frequencies.
LW band: can save 10 (00 ~ 09) frequencies.
GB-10
89.8
FM
50
"E" flashes
89.8
FM
50
Auto Tuning Storage (ATS
1. Select the band.
2. Long press < > until frequency changing. The unit
will auto tune and save all strong signal into memory.
(FM and SW freq. will be saved from the address (50),
MW freq. will be saved from the address (15), LW freq.
will be saved from the address (05).
long press
NOTE:
1. While ATS, please get very close to the window or stand on the outdoor field
to avoid the interrupt and gain the best reception.
2. The new frequencies will cover the old ones if the radio is being ATS once
again.
3. While ATS, please disconnect the adaptor and the radio in order to avoid
the interrupt by the adaptor.

Recall the Stored Frequency

1. Select the band.
2. Press < > or < > shortly.
press shortly
NOTE:
While recalling the stored frequency, the unit
will jump over the empty address automatically.
RADIO OPERATION
)
89.8
FM
50 05
FM freq. will be saved from
the address (50).
GB-11