Supplies Required; Assemble Components; Connect Water Supply - Bradley S19-120 Manual Del Usuario

S19-120, S19-120A

Supplies Required

• Teflon tape and pipe sealant
• Piping to 1" NPT water supply inlet
• Adequate supply pipe supports
• Minimum 4" (102 mm) drain to accommodate
30 gallons (115 liters) per minute discharge for
shower waste
• Sign-mounting hardware

Assemble components

1. Assemble the components as shown on page 4
(S19-120) or page 5 (S19-120A).
2. Apply pipe sealant to all male-threaded pipe joints.
3. Use the rubber grip pad provided or a strap
wrench around pipes when tightening to prevent
marring. Place the grip pad on the pipe, then put
the wrench over the grip pad and turn the pipe
with the wrench.
4. Bottom edge of showerhead should be 84"
(2134 mm) from the floor.

Connect water supply

NOTICE! Do not rely on Bradley's Drench Shower to
support supply piping.
1. Connect water supply piping to 1" NPT inlet
on unit (piping supplied by installer). Provide
adequate supports (supplied by installer) for
supply pipe using pipe hangers or other means.
2. Mount the safety sign to the wall using sign-
mounting hardware supplied by installer.
3. Open water supply lines. Test for leaks and
adequate water flow.
All dimensions assume standard thread
engagement. Variations in manufacturing
allow for +/- 1/8" (3 mm) per threaded joint.
To find the tolerance of a dimension, add
the number of thread joints in between a
dimension and multiply it by 1/8" (3 mm).
4 2/15/2021
(400 mm)
Ø 3.1"
(78.7 mm)
84"
(2134 mm)
to Floor
S19-120
15¾"
(400 mm)
Ø 10¾"
(273 mm)
84"
(2134 mm)
to Floor
65¼"
(1657 mm)
to Floor
S19-120A
Bradley • 215-148 Rev. B: ECO 19-05-034A
Installation
15¾"
91-13/16" 88½"
(2332 mm) (2248 mm)
to Floor to Floor
63-13/16"
(1620 mm)
to Floor
93¼"
(2368 mm)
to Floor
90"
(2284 mm)
to Floor