Maintenance; General; Maintenance Schedule; General Inspection - Husqvarna WC 48 Se Manual De Instrucciones

General

WARNING! The user must only carry out the
!
maintenance and service work described in
this Operator's Manual. More extensive work
must be carried out by an authorized service
workshop.
Prevent unintentional starting by removing
the ignition cable from the spark plug.
The life span of the machine can be reduced
and the risk of accidents can increase if
machine maintenance is not carried out
correctly and if service and/or repairs are
not carried out professionally. If you need
further information please contact your
nearest service workshop.
• Let your Husqvarna dealer regularly check the machine
and make essential adjustments and repairs.
• Always use genuine accessories.

Maintenance schedule

In the maintenance schedule you can see which parts of your
machine that require maintenance, and with which intervals it
should take place. The intervals are calculated based on daily
use of the machine, and may differ depending on the rate of
usage.
Weekly
Daily maintenance

maintenance

General inspection

Spark plug
Vibration

External cleaning

damping system*

Oil level

Muffler*

Cutting equipment

Battery
Cutting cover and
protective cover*
Engine brake handle*
*See instructions in the section "Machine's safety
equipment".
MAINTENANCE
General inspection
•
External cleaning
•
•
•
•
•
Oil level
The lawn mower should stand on flat ground when you check
the oil level. Check the oil level with the dipstick on the oil filler
cap.
•
•
•
Cutting equipment
Monthly
•
maintenance
Replacing and
adjusting the V-
•
belt
Replacing and
Replacing the blades
adjusting the
centre belt
Air filter
Oil change
Oil filter
Fuel system
Dismantling
•
•
Check that nuts and screws are tight.
Brush leaves, grass and the like off of the lawn mower.
Do not use a high pressure washer to clean the machine.
Never flush water directly on the engine.
Clean the air intake on the starter. Check the starter and
starter cord.
When cleaning under the cutting hood, turn the machine
with the spark plug upwards. Empty the fuel tank.
Remove the oil cap and wipe the dipstick clean.
Put the dipstick back in. The oil filler cap must be
completely screwed down to give a correct picture of the
oil level.
If the oil level is low, fill using engine oil up to the upper
level on the dipstick.
Check the cutting attachment for damage or cracks. A
damaged cutting attachment should always be replaced.
Always ensure the cutter is well ground and balanced
correctly.
WARNING! Always wear heavy-duty gloves
!
when servicing and maintaining the cutting
equipment. The cutters are very sharp and
cuts can occur very easily.
Unscrew the bolt holding the cutter.
Remove the old blade. Make sure the blade bracket is free
of damage. Also check that the cutter bolt is undamaged
and that the engine shaft is not bent.
– 43
English