Air Filter; Oil Change; Oil Filter; Fuel System - Husqvarna WC 48 Se Manual De Instrucciones

Air filter
• Remove the air filter cover and take out the filter.
• Clean the filter by knocking the filter against a flat surface.
Never use solvent with petroleum, for example, kerosene,
or compressed air to clean the filter.
• An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced
with a new one at regular intervals. A damaged air filter
must always be replaced.
• When reassembling, make sure that the filter completely
seals against the filter holder.

Oil change

• Empty the fuel tank.
• Unscrew the oil filler cap.
• Place a suitable vessel to collect the oil in.
• Drain the oil by tipping the engine so that the oil runs out
through the filler pipe. Ask where you can dispose of
surplus engine oil at your local petrol station.
• Fill with new engine oil of a good quality. See instructions
in the section "Technical data".
Oil filter
WARNING! The oil filter gets very hot during
!
and after use. Always wear heavy-duty work
gloves when dismantling the oil filter.
• Unscrew the oil filler cap.
• Place a suitable vessel to collect the oil in.
• Drain the oil by tipping the engine so that the oil runs out
through the filler pipe. Ask where you can dispose of
surplus engine oil at your local petrol station.
• Unscrew the oil filter. Ask at your local petrol station where
you can dispose of the used oil filter.
• Lightly lubricate the rubber seal on the new oil filter using
new oil.
• Screw the oil filter back. When the gasket touches the
fixing, tighten 1/2 to 3/4 turn.
• Fill with new engine oil of a good quality. See instructions
in the section "Technical data".
• Start the engine. Check for leaks while the engine is
heating up.
• Stop the engine. Check oil level and top up if necessary.

Fuel system

• Check that the fuel cap and its seal are not damaged.
• Check the fuel hose. Replace if necessary.
MAINTENANCE

Recycling

This machine has the prerequisites to last for many years.
This minimizes the machine's environmental impact. Perform
service and maintenance according to the instructions in this
manual. This way the engine will last longer and the
hazardous emissions are minimized.
When the service life of this product has been served and it is
no longer used it should be returned to the dealer or to an
applicable station for recycling. The machine is dismantled
and the parts are divided up in different materials for
recycling. Most parts of this machine are recyclable.
– 45
English