Kohler K-3145 Guia De Instalacion página 5

Clip
Tooth
Clip Jaw
Mounting Holes
Hex Nut
2. Install the Clips
Turn the sink upside down onto a clean, soft surface.
Slide the clips over the predrilled mounting holes in the sink rim.
Refer to the illustration for correct clip positions (three clips on
the front and back; two on each side).
NOTE: Make sure the clip teeth are fully seated in the mounting
hole.
Turn all the clip jaws parallel to the sink rim.
3. Install the Faucet Fitting
Install the faucet and drain fitting according to the manufacturer's
instructions.
NOTE: If you are reusing fittings from an old sink, use plumbers
putty under the faucet base and top flange of the strainer.
Kohler Co.
Clip Placement
5 1013270-2-E