Allmand 725 Instrucciones De Instalación página 8

20. Loosen the screw on AC post 2 of 725 light relay 2 and
3. Connect the fork terminal on the wire (W, Figure
18a) that is leading from either light switch 3 or 4 onto
the post 2 of relay 2. Connect the fork terminal on the
wire (X, Figure 18a) that is leading from either light
switch 5 or 6 onto the post 2 of relay 3. Tighten down
the screws onto the fork terminals.
21. On Zettler light relay 2 disconnect the existing 16
AWG black wire (Y, Figure 18a-b) from the DC ground
spade. This wire should be leading from the divider
panel of the component block. On Zettler relay 1
disconnect the 16 AWG black wire from the same
spade.
18a
Zettler Relay 2
18b
725 Relay 2
725 Relay
Disconnection Detail
8
725 Relay 2
725 Relay 3
W
725 Relay 3
X
W
18c
Zettler Relay 2
Zettler Relay
Disconnection Detail
22. Cut off and discard the female spade terminal from the
wire that was connected to the Zettler relay. Strip off
the appropriate amount of wire insulation and install
wire (Z, Figure 17) into a 5 pin lever lock (AA, Figure
17, Ref. 10) from the kit contents.
19
Y
X
AA
23. From the kit contents, locate and select the black 16
AWG wire (BB, Figure 20, Ref. 2). Cut the black 16
AWG wire in thirds, and strip the ends of the cut wires.
On each of the cut wires crimp a blue fork terminal
(CC, Figure 20, Ref. 8) on one of the ends.
Y
Z
www.allmand.com