Warranty - Everbilt EBTP1 Guía De Uso Y De Mantenimiento

Safety Information (continued)
WARNING: Wear safety goggles at all times when
working with pumps.
WARNING: When possible, connect the pump
DIRECTLY to a grounded, GFCI outlet. Extension
cords may not deliver sufficient voltage to the pump
motor. Extension cords present a life-threatening
safety hazard if the insulation becomes damaged or
the connection ends fall into water. If using 25 ft.
extension cord, use 16-gauge wire or thicker. If
using a 50 ft. cord, use 14-gauge wire or thicker.
WARNING: Protect the electrical cord from sharp
objects, hot surfaces, oil, and chemicals. Avoid
kinking the cord. Do not use damaged or worn
cords.
WARNING: Never operate this pump unless it is
secured to a solid foundation. Do not suspend the
pump by the discharge hose or power cord. Keep
the pump suction strainer clear.
WARNING: Ensure that the electrical circuit to the
pump is protected by a 15-amp minimum fuse or
circuit breaker.
CAUTION: Know the pump and its applications,
limitations, and potential hazards.
CAUTION: Periodically inspect the pump and
system components to ensure the pump suction
screen is free of mud, sand, and debris. Disconnect
the pump from the power supply before inspecting.
CAUTION: Follow all electrical and safety codes,
particularly the National Electrical Code (NEC) and
in the workplace, the Occupational Safety and
Health Act (OSHA).
IMPORTANT: Ensure the electrical power source is
adequate for the requirements of the pump.
IMPORTANT: When the pump is running dry, it will
be EXTREMELY LOUD. This is a sign to unplug the
pump.

Warranty

The manufacturer warrants to the original purchaser that it will be free from any defect in materials and/or workmanship
for one (1) year from date of purchase. This limited warranty is extended ONLY to the original purchaser, and only covers
products purchased as new. If during this one-year period, the original purchaser experiences a defect which is covered
by this limited warranty, it will be repaired or replaced (at manufacturer's sole option) at no cost to the purchaser.
Defective parts will be repaired or replaced with new or factory rebuilt parts at the manufacturers' sole option.
The purchaser must pay all labor and shipping charges necessary to replace the product covered by this warranty.
IMPORTANT: For safety, this pump motor has an
automatic resetting thermal protector that
automatically turns the pump off if it becomes too
hot. Overuse of this feature will damage the
pump and will void the warranty.
IMPORTANT: DO NOT RUN THE PUMP DRY. The
pump depends on water for cooling and lubrication.
Operating the pump without water may cause the
motor to overheat or cause damage to parts of the
pump. It may also shorten the life of your pump.
IMPORTANT: This pump is made of high-strength,
corrosion-resistant materials. It will provide trouble-
free service for many years when properly used and
maintained. However, inadequate electrical power
to the pump, or blockage by ice, dirt, or debris may
cause the pump to fail. Please carefully read the
manual and follow the instructions regarding
common pump problems and remedies.
IMPORTANT: Do not leave pump unattended while
in operation. Always make sure the pump is
unplugged as soon as the water level reaches 1/8
in. At water levels less than this, the pump is
attempting to pump air, which will cause the pump
to be damaged. Running the pump without sufficient
water will damage the pump and void the warranty.
IMPORTANT: You must use the included clear
suction hose on the inlet of this pump, as marked on
the pump. Before using this pump, check the hose
for holes or excess wear, which could cause leaks.
Ensure the hose is not kinked or making sharp
angles. A straight hose allows the pump to move the
greatest amount of water quickly. Also check that all
hose connections are tight to minimize leaks.
IMPORTANT: This pump is not intended for use in
sewage or septic systems. Doing so will void
warranty.
IMPORTANT: Always use one of the suction
strainers included with this pump to prevent debris
from damaging the pump.
3
Please contact 1-844-251-7446 for further assistance.
HOMEDEPOT.COM