Operating The Pump - Everbilt EBTP1 Guía De Uso Y De Mantenimiento

Installation (continued)
Setting the pump on a
5
sturdy base
□
Set the pump (A) on a sturdy base (table, board,
etc.) to prevent it from tipping over. Make sure the
hoses are as straight as possible.
DANGER: This pump CANNOT be submersed in
water, and the motor CANNOT get wet at all.
Getting the motor wet could cause electrocution,
which could lead to serious injury or death!
NOTE: Do not coil or kink the hose.
A
6

Operating the pump

□
Plug the pump (A) into a GFCI outlet.
□
Unplug the pump when water has been removed
down to 1/8 in.
NOTE: This pump can be very loud when plugged
in. THIS IS NORMAL. Once water begins to pump,
the noise will dissipate. When the water level has
been reduced to approximately 1/8 in., you MUST
UNPLUG THE PUMP. DO NOT RUN DRY. The
pump will be EXTREMELY LOUD when the pump is
no longer pumping water.
NOTE: If water is not being pumped within 30
seconds, unplug the power cord and check the
connection on the two ends of the inlet hose to
make sure there are no air leaks. Then, add water
into the inlet again and repeat the process.
A
6
Please contact 1-844-251-7446 for further assistance.
Min.1/2 in.
HOMEDEPOT.COM