Craftsman CMEBL7000 Manual De Instrucciones página 8

English
Fig. G
Fig. H
Attaching Flexible Tube to Power head
(Fig. I)
1. Align the power head
as shown in Fig. I.
2. Push the flexible collection tube assembly onto the
power head until it is in the fully locked position and an
audible click is heard. (Fig. I).
3. To seal the back pack collection bag
zipper so the opening is closed.
Fig. I
12
Adjusting Harness (Fig. J)
1. Place the shoulder straps
2. Pull the adjustment straps
is firm against your back as shown in Fig. J.
6
18
1 and flexible collection tube
8 , zip up the bag
1
14 over your shoulders.
15 down until the backplate
Fig. J
2
9
14
Removing Blow Tube or Flexible
Collection Tube (Fig. I)
To remove the blow tube, flexible collection tube, depress
the release button on the power head and pull straight off
(Fig. I).
OPERATION

WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.

WARNING:
glasses. Wear a filter mask if the operation is dusty.
Use of rubber gloves and substantial footwear is
12
recommended when working outdoors.

WARNING:
daylight or good artificial light.
Switching On and Off (Fig. K)

WARNING:
product firmly when switching on.

CAUTION:
self or bystanders.

WARNING:
for approximately 5 seconds after it has been switched
off. Use both hands to grip the tool and let the motor
come to a complete stop before setting the tool down.
Your blower vac is fitted with a ON/OFF switch
the top of the handle.
• To turn tool ON, slide the ON/OFF switch forward to the
ON position "1".
• To turn tool OFF, slide the ON/OFF switch backward to
the OFF position "0".
15
To reduce the risk of
Always wear safety
Use blower/vac only in
Use both hands to grip the
Do not point unit discharge at
The tool will continue to run
14
15
1 located on