GYS NOMAD POWER PRO 12XL Manual De Instrucciones página 12

Translation of the original instructions
OUTPUT 12V USB USB Charging
ON/OFF OUTPUT 5V/2.1A 5V/2.1A 18V/2A Error
STRAP FASTENING
USE AS A BOOSTER
RECHARGE THE NOMAD POWER before first use and after each use.
Before use, make sure that the NOMAD POWER is charged to at least 50% of its load capacity. A charged
booster guarantees vehicle starting and allows the 118.4 Wh (PRO 12 XL) / 236.8 Wh (PRO 24 XL) to be
used to charge a wide range of accessories.
1
OUTPUT 12V USB USB Charging Error
ON/OFF OUTPUT 5V/2.1A 5V/2.1A 18V/2A
2
3
5
6
12
NOMAD POWER PRO 12 XL / 24 XL
1 - Plug the car adaptor (11) to the vehicle's cigarette lighter socket.
2 - Connect the other end of the adapter to the 18 V/2 A charging port (7) of the NOMAD
POWER to start charging.
Put the NOMAD POWER on a flat surface. Secure it by inserting the safety strap into the
handle and attaching it securely to the vehicle using the carabine hook provided.
Switch on the booster by pressing the main switch (2), it becomes illuminated and the
display lights up.
Disconnect the red and black clamps from the booster. A flashing red and green «8» appears
on the display. It indicates that the charger is looking for a battery.
1- Connect the red clamp to the (+) of the battery.
2- Connect the black clamp as far as possible from a fuel hose or fitting and as close as
possible to the starter ground.
The LED indicator shows a green «8» to indicate that the battery is detected and properly
connected.
If the LED (8) lights up and a red «8» appears on the display, it means that there
is an error that needs to be corrected. Refer to the fault codes (PRO 12 XL) or the
table «Troubleshooting» (PRO 24 XL) of this manual.
Turn the ignition key to the on position and start the engine.
After starting, disconnect the battery clamps from the battery and replace the clamps on the
booster.
Leave the vehicle running.
!
EN