Installation Using The Screw Holes On The Side Of This Product; Installation With The Holder - Pioneer DMH-A241BT Guía De Iniciación Rápida

5 cm
Leave ample
space
5 cm
Before installing this
product
1
Insert the supplied extraction keys
into both sides of the unit until they
click into place.
2
Pull the unit out of the holder.
Extraction key
Installation with the
holder
1
Install the holder into the dashboard.
2
Secure the mounting sleeve by using a
screwdriver to bend the metal tabs
(90°) into place.
182 mm
112 mm
Dashboard
Holder
3
Install this product into the holder.
Dashboard
4
Attach the trim ring.
Trim ring
Groove
Attach the trim ring with the side
with a groove facing downward.
Installation using the screw
holes on the side of this
product
1
Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Flush surface screw
Be sure to use the screws supplied
with this product.
Installing the
microphone
• Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver's
voice.
• Be sure to turn off (ACC OFF) the product
before connecting the microphone.
• Depending on the vehicle model, the
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install the
microphone on the steering column.
Mounting on the sun
visor
1
Fit the microphone lead into the
groove.
Microphone lead
Groove
2
Attach the microphone clip to the sun
visor.
En
13