Instructions For Correct Use, Safety Instructions - Brill A 12(e) Manual De Instrucciones

pack A12(e) from the appliance
by pushing the locking lever
down and pulling the Brill Power
pack A12(e) out.
7. Storage and maintenance of Brill power pack A12(e)
Keep the Brill Power pack
A12(e) at a dry, frost-proof
place. Avoid direct insulation.
Make sure that the contacts on
the Brill Power pack A12(e) are
always clean (fig. A Pos. 2).
Remove any dirt with a soft dry
cloth, never under running water.
If you do not use the Brill Power
pack A12(e) for a longer time,

8. Instructions for correct use, safety instructions

Always use the equipment
solely for the purpose described
in the operating instructions.
Charge the power pack prior to
first start-up for a full 24 hours
please.
Never recharge the power pack
after it has been heated up
by being used or by sunlight.
Let cool down first.
During charging, the mains plug
and the power pack will slightly
warm up.
When the appliance is active,
the Brill Power pack A12(e) will
heat up. This is normal and does
in no way deteriorate device
output.
or if you want to store it, you
have to recharge it before.
During storage, gradual self-
discharge will occur. Impera-
tively recharge the Brill Power
pack A12(e) after longer
periods of storage prior to first
use.
Adhere to Instructions for use
of Brill Power pack A12(e) and
Brill charger LG12
Only use the charger in dry
rooms and never in direct sun-
light.
Make sure that no easily inflam-
mable substances are located
next to the appliance during
charging.
Only charge the Brill power
pack A12(e) with the Brill
charger LG12.
If you operate peripheral equip-
ment, first unplug the charger
from the power pack.
GB
17