Nexgrill 720-0697E Manual Del Usuario página 12

8. Diagonal Bar Barrier Assembly
Loosen but do not remove the one screw
which is pre-assembled on the Bottom
Panel . Secure solid end of the Diagonal
Bar Barrier (Y) to the underside of the Front
Panel (S) through the middle hole with screw
removed in step 5,then secure other end of Diagonal
Bar Barrier (Y) by clipping the open hole onto
the screw which pre-assembled on the Bottom
Panel (B). Tighten the loosened screw.
As shown in Fig. 10.
9. Cart Beam Assembly
Insert the Cart Beam (R) into Cart Leg, Back
Left (G) and Cart Leg, Back Right (J), aligning
the holes. The Cart Beam (R) will fit into holes.
As shown in Fig. 11.
10. Firebox Assembly
NOTE: We suggest two persons lift the firebox
when assembling. Be sure to remove all packaging
material during assembly.
a) Remove two screws which are pre-assembled
on the Cart Leg Back Right (J) and Cart Leg
Back Left (G). As shown in Fig. 13.
b) Remove the four screws that are attached to
cart frame (H). 2 screws on the left and 2 on
the right.
c) Remove the Firebox Assembly (A) from the
carton and carefully place onto the grill cart.
Lid handle will face front and be above
front panel. As shown in Fig. 12.
Fig. 10
B
Fig. 11
G
Fig. 12
12
Y
S
Y
S
R
A
J