d) Once the firebox is in place, secure the Firebox
Assembly (A) to Cart Leg Back Right (J) and
Cart Leg Back Left (G) using the screws removed
in step 10a. As shown in Fig. 13. A.
Note: Gas hose and regulator will be in front of Cart
Leg, Front Right (I).
e) Install the four screws that were removed in step
10b securing the firebox to the cart frames. As
shown in Fig. 13. B.
11. Side Burner Shelf Assembly
a) Loosen but do not remove the screw which
is pre-assembled on the cart leg. Remove
the two screws that are attached to the Side
Burner Shelf (D) frame and the two screws that
are attached to the main control panel.
b) Align the holes on Side Burner Shelf (D) with
the loosened screws located on the cart leg.
c) Secure Side Burner Shelf (D) from inside firebox
using two screws that were remove in step
11a to attach the Side Burner Shelf (D) to the
main firebox.
d) Secure the Side Burner Shelf Control Panel (D)
and main control panel by two screw s which are
pre-assembled on the main control panel.
As shown in Fig. 14. Tighten all screws.
e) Tighten screws loosened in 11a. Ensure all
screws are tight.
Fig. 13. A
A
J
Fig. 13. B
Fig. 14
13
G
D