Resetting The Electrical Back-Up Heater; Checking Tightness; Checking The Electrical Installation; Decommissioning - Vaillant VWZ MEH 60 Instrucciones De Instalación Y Instrucciones De Uso

Ocultar thumbs Ver también para VWZ MEH 60:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.3

Resetting the Electrical back-up heater

In case of an abnormal increase in water temperature, the
heating element's safety thermostat may be triggered (Refer
to the installation manual control box).
It has to be reset manually.
i
Notes
Let the heating element cool before
resetting.
1
Key
1
Reset button
∙ Press the reset button (1).
6.4

Checking tightness

∙ Check the water-tightness of the system.
6.5

Checking the electrical installation

∙ Check the electrical installation observing all relevant
regulations.
6.5.4.1
Checking the cables
∙ If the power cable of this product is damaged, then to
prevent danger, only the manufacturer, the after-sales
service or similarly qualifi ed persons shall replace the
power cable.
∙ When replacing the power cable see chapter 4.4 and 4.5.
7

Decommissioning

∙ Isolate the product from the power mains.
∙ Drain the appliance (see chapter 6.2).
∙ De-install the product.
∙ Recycle or dispose the product and its components (see
chapter 8).
0020152779_02 - 04/13 - Vaillant
DECOMMISSIONING
8

Recycling and disposal

8.1

Recycle the packaging

∙ Sort the waste to separate those which can be recycled
(cartons, plastics...) from those that cannot (strapping ...).
∙ Recycle the product packaging according to all relevant
regulations.
8.2
WEEE: Recycle or dispose the product
and its components
The product must be recycled under the WEEE Directive
(Waste Electrical and Electronic Equipment), which
specifi es:
- the selective collection of waste electrical and electronic
equipment.
- the selective systematic treatment of certain components
and substances considered as dangerous,
- the reuse, recycling and recovery of the collected WEEE.
∙ Do not dispose of your product or any of its
accessories in the household waste.
∙ Make sure the old unit and any accessories are
disposed of properly.
∙ Deposit the product at an appropriate collection point for
the treatment, evaluation and recycling of WEEE.
∙ Observe all relevant regulations.
i
Notes
By adhering to this directive, you are
helping the environment and contributing to
the preservation of natural resources and
the protection of human health.
9

Technical data

Description
CE number (PIN)
Net Weight
Central heating maximum
hydraulic pressure
(PS
max)
H
Central heating minimum
hydraulic pressure
(PS
min)
H
Electrical
Voltage / frequency
Maximum absorbed power (P
max)
Maximum Current (I max)
Index of electrical protection
Cable size
Unit
kg
4
bar
3.0
Mpa
0.3
bar
0.5
Mpa
0.05
V~/Hz 230/50 230/50 400 /50
kW
6
4
6
A
30
20
10
IP X4
-
3 G4
5 G1.5
EN
26

Publicidad

Tabla de contenido
loading

Tabla de contenido