Changing The Oil - MTD Cub Cadet CC4125 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Push the trimmer line until it
lies flat against the cutting
head (Fig. 23). Make sure the
two lengths of cutting line are
of equal length. If they are
not, adjust until they are.
WARNING:
Always use the correct line length when
installing trimming line on the unit. If the two lengths of
cutting line are not of equal length, the unit may develop
a vibration.
CHECKING THE OIL LEVEL
WARNING:
To prevent extensive engine wear
and damage to the unit, always maintain the proper
oil level in the crankcase. Never operate the unit
with the oil level below the bottom of the dipstick.
The importance of checking and maintaining the proper oil level in the
crankcase cannot be overemphasized. Check oil before each use:
1.
Stop the engine and allow oil to drain into the crankcase.
2. Place the unit on a flat, level surface to get a proper oil
level reading.
3. Keep dirt, grass clippings and other debris out of the
engine. Clean the area around the oil fill plug/dipstick
before removing it.
4. Remove the oil fill plug/dipstick and wipe off oil. Reinsert it
all the way back in.
5.
Remove the oil fill plug/dipstick and check the oil level. Oil
should be up to the top of the dipstick (Fig. 24).
Oil Fill Plug/Dipstick
O-Ring
Full
Add 1.4-1.5 Oz.
(41-44 ml)
6. If the level is low, add a small amount of oil to the oil fill
hole and recheck (Fig. 25). Repeat this procedure until the
oil level reaches the top of the dipstick.
NOTE: Do not overfill the unit.
NOTE: Make sure the O-ring is in place on the oil fill plug/dipstick
when checking and changing the oil (Fig. 25).
MAINTENANCE AND REPAIR INSTRUCTIONS
Fig. 22
Fig. 23
Top of Dipstick
Fig. 24
O-Ring
Oil Fill Plug/Dipstick
Oil Fill Hole

CHANGING THE OIL

For a new engine, change the oil after the first 10 hours of operation.
Change the oil while the engine is still warm. The oil will flow freely
and carry away more impurities.
1. Unplug spark plug boot to prevent accidental starting.
2. Remove the oil fill plug/dipstick.
CAUTION:
Wear gloves to prevent injury when
handling the unit.
3. Pour the oil out of the oil fill hole and into a container by
tipping the unit to a vertical position (Fig. 26). Allow ample
time for complete drainage.
4. Wipe up any oil residue on the unit and clean up any oil that
may have spilled. Dispose of the oil according to Federal,
State and local regulations.
5. Refill the crankcase with 3.04 fluid ounce (90 ml) of SAE 30
SF, SG, SH oil.
NOTE: Use the bottle and spout saved from initial use to measure
the correct amount of oil. The top of the label on the bottle
measures approximately 3.4 ounces (100 ml) (Fig. 27).
Check the level with the dipstick. If the level is low, add a
small amount of oil and recheck. Do not overfill (Fig. 27).
6. Replace the oil fill plug/dipstick.
7. Reconnect the spark plug boot.
Fig. 25
Fig. 26
Fill Level
Fig. 27
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cub cadet cc4175

Tabla de contenido