AEG Electrolux DL8560-M Manual Del Usuario página 21

21
ACTIVATED CHARCOAL FILTER (RECIRCULATION VERSION)
The fi lter is not washable and cannot be regenerated. It must be replaced when led S1 fl ashes or
at least every 4 months. The alarm signal will only light up when the extractor motor is switched
on.
Alarm signal activation
• In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at
a later date. Turn the Lights and the suction Motor off.
• Disconnect the Hood using the Main switch or the double-pole switch on the mains power sup-
ply.
• Restore the connection by pressing and holding T1.
• Release the button. All fi ve LEDs are turned on.
• Within 3 seconds press T1 until LEDs T1 and T4 fl ash in confi rmation:
- LED fl ashes twice - Activated charcoal fi lter saturation alarm ENABLED.
- LED fl ashes once - Activated charcoal fi lter saturation alarm DISABLED.
REPLACING CHARCOAL FILTERS
Alarm signal reset
• Switch off the lights and extractor motor.
• Press button T3 for at least 3 seconds, until the leds
start to fl ash.
Replacing the Filter
• Pull the Comfort Panel to open it.
• Remove the metal grease fi lters
• Remove the saturated activated carbon fi lter by releas-
ing the fi xing hooks
• Fit the new fi lter by hooking it into its seating
• Replace the metal grease fi lters.
LIGHT REPLACEMENT
20 W halogen light.
• Extract the lamp from the lamp holder by pulling
gently.
• Replace with another of the same type, making sure
that the two pins are properly inserted in the lamp
holder socket holes.
All manuals and user guides at all-guides.com
LIGHTING
EN