Installing The Bfs Assembly - SMA NR-STP-BFS.BG4 Manual De Instrucciones

SMA Solar Technology AG
2. Unlock the fixing domes of the BFS assembly and
carefully pull the assembly forwards from the fixing
domes.
7

Installing the BFS assembly

A
A
Figure 2 : Handling area of OCS
Position Designation
A Area of the assembly STP-BFS that can be touched without consequence
This area can be used as a holding point during mounting.
Rest No other areas may be touched
Procedure:
1.
Damage to the assembly due to mechanical strain
If the assembly is excessively bent, solder contacts, components and conducting paths may
snap.
2. Place the OCS assembly onto the fixing domes directly from above and press lightly only at
the positions shown until the OCS assembly snaps into place on the fixing domes.
3. Affix the new type label over the existing type label on the inverter. The inverter is issued with
a new serial number due to the replacement of the OCS assembly.
4. Recommission the inverter see section 8, page 18.
Replacement Manual
NOTICE
BFS-STPTLEE-10-RM-xx-10
7 Installing the BFS assembly
A
A
17