Defiant DFI-0654-WH Guía De Referencia Rápida

Quick Reference Guide
Motion Security Light
IMPORTANT: This guide is a quick reference only for common features of the product and
troubleshooting tips. Please read and reference the full instruction manual for installation, safety,
and additional information.
This light operates with a battery charged from a solar panel. If the voltage of the nickel-metal
hydride (Ni-MH) batteries run down to 3V, the light will not activate when the motion sensor is
triggered. When the solar panel has recharged the Ni-MH batteries, and voltage is above 3V, the
light will return to normal operation.
INSTALLATION OPTIONS
Eave Mount
Wall Mount
Physical Adjustment Options
Item #1005 536 760
Model #DFI-0654-WH
ADJUSTING THE LAMP HEADS
□ If needed, gently grasp the lamp heads (A) and tilt
them up or down or side-to-side to adjust the light
coverage area.
Settings Adjustments and Indicators
POWER BUTTON (D)
□ Turns the unit off when not in regular
operation, to conserve battery.
D
Troubleshooting
Problem
The light will not turn
ON at night.
Incorrect
SETTING THE SENSOR FOR WALL OR EAVE
MOUNTING
NOTE: Adjust the sensor angle to the coverage
desired.
A
□ For wall mounting, tilt the sensor (C) down to an
almost 90º angle, and turned side-to-side to cover
a general area.
□ For eave mounting, turn the sensor (C) outward or
side-to-side.
LED INDICATOR (1)
□ Flashing Red Twice: Motion Detected
□ Solid Green: Battery Charging
MOTION TEST
□ Switches between the regular operation
(MOTION) mode, and TEST mode.
TIME ADJUSTMENT
□ Sets how many minutes after motion is
detected that the light stays on
(30 to 90 seconds).
Possible Cause Solution
The Power button is OFF. Make sure the Power button is in the ON position.
The batteries may be depleted. Check the connections between light and panel. Ensure the panel receives ample sunlight.
The extension cord between the solar panel and Connect to a shorter extension cord, or reposition the solar panel closer to the light fixture.
light fixture is longer than 60 ft.
The solar panel is not positioned correctly. The solar panel must face South and have clear exposure to the sun.
The motion sensor is not detecting motion. Increase the SENS and decrease the LUX to make the unit more sensitive to motion in the dark.
Light from other sources (light poles, headlights) Increase the LUX setting to compensate for the additional light sources.
is not allowing the unit to activate.
The air temperature is too hot or too cold. The light will operate normally when temperatures return within operational range.
ADJUSTING THE SOLAR PANEL
IMPORTANT: The solar panel (E) must receive
as much direct sunlight over the course of the
day as possible. Keep in mind that shadows may
block the sunlight form reaching the solar panel
(E) during the day.
□ Rotate the solar panel (E) to the desired angle.
C
C
SENS ADJUSTMENT
□ Adjusts sensitivity of motion
sensor. Set to H for long range
or summer months or L for less
coverage or winter months.
LUX ADJUSTMENT
□ Set to L to turn the light on at
night or in a very dark area. Set
to H to turn the light on at dusk,
or in bright areas.
Please contact 1-866-308-3976 for further assistance.
E
1
HOMEDEPOT.com