Defiant DFI-0760-WH Guía De Referencia Rápida

Quick Reference Guide
Motion Security Light
IMPORTANT: This guide is a quick reference only for common features of the product and
troubleshooting tips. Please read and reference the full instruction manual for installation, safety,
and additional information.
This light operates with three (3) AA Ni-MH batteries charged from the solar panel.
The batteries are included and installed in the light. If the voltage of the nickel-metal hydride
batteries run down to 3V, the light will not activate when the motion sensor is triggered. When
the solar panel has recharged the Ni-MH batteries, and voltage is above 3V, the light will return to
normal operation.
INSTALLATION OPTIONS
A
Wall Mount Eave Mount
Physical Adjustment Options
Item #1009 183 370
Model #DFI-0760-WH
ADJUSTING THE LAMP HEADS
□ If needed, gently grasp the lamp heads (A) and tilt
them up or down or side-to-side to adjust the light
coverage area.
Settings Adjustments and Indicators
POWER BUTTON (D)
□ Turns the unit ON/OFF. Keep the unit
ON for continuous operation.
Troubleshooting
Problem
The light will not turn
ON at night.
Incorrect
SETTING THE SENSOR FOR WALL OR EAVE
MOUNTING
NOTE: Adjust the sensor angle to the coverage
desired.
A
□ For wall mounting, tilt the sensor (C) down to an
almost 90º angle, and turned side-to-side to cover
a general area.
□ For eave mounting, turn the sensor (C) outward or
side-to-side.
INDICATOR LIGHT (1)
□ Flashing Red Twice: Motion Detected
□ Solid Green: Battery Charging
MOTION TEST
□ Switches between the regular operation
(MOTION) mode, and TEST mode.
TIME ADJUSTMENT
□ Sets how many minutes after motion is
detected that the light stays on
B
(30, 60, 90 seconds).
D
Possible Cause Solution
The Power button is OFF. Make sure the Power button is in the ON position.
The batteries may be depleted. Check the connections between light and solar panel. Ensure the panel receives ample sunlight.
The extension cord between the solar panel and Connect to a shorter extension cord, or reposition the solar panel closer to the light fixture.
light fixture is longer than 60 ft.
The solar panel is not positioned correctly. The solar panel should face the southern sky, and have clear exposure to the sun.
The motion sensor is not detecting motion. Increase SENS, and turn LUX towards the moon icon.
Light from other sources (light poles, headlights) Turn the LUX setting towards the sun icon to compensate for the additional light, or move the
acts similar to daylight to the light sensor. light to another area.
The air temperature is too hot or too cold. The light will operate normally when temperatures return within operational range.
ADJUSTING THE SOLAR PANEL
IMPORTANT: The solar panel (E) must receive
as much direct sunlight over the course of the
day as possible. Keep in mind that shadows may
block the sunlight form reaching the solar panel
(E) during the day.
□ Rotate the solar panel (E) to the desired angle.
C
C
SENS ADJUSTMENT
□ Adjusts sensitivity of motion
sensor. Set to H for long range
or summer months or L for less
coverage or winter months.
LUX ADJUSTMENT
□ Set to moon to turn the light on
at night or in a very dark area.
Set to sun to turn the light on at
dusk, or in bright areas.
Please contact 1-866-308-3976 for further assistance.
E
HOMEDEPOT.com