Russell Hobbs 19450-56 Instrucciones página 67

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
diagrams
0 off
1 low
2 high
3 speed control
15 Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer
timings and slower speeds.
16 Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and
higher speeds.
17 Don't run the motor for more than 1 minute, or it may overheat. After 1 minute, switch off for
at least 2 minutes, to let the motor cool.
Y PULSE
18 Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In
this direction, the knob is spring-loaded. When you let go, it'll return to 0.
C ADDING INGREDIENTS
19 To add ingredients while the blender is working, remove the cap, pour the new ingredients
through the hole, then replace the cap.
20 Check that the added ingredients don't push the volume in the jug past the 1500ml mark.
C FINISHED?
21 Switch off (0), and wait till the blades come to a stop before removing the lid from the jug, or
removing the jug from the motor unit.
C CARE AND MAINTENANCE
22 Switch the appliance off (0) and unplug it.
23 Wipe the outside of the motor unit with a clean damp cloth.
24 Wash the removable parts in warm soapy water, rinse well, drain, and air dry.
25 Don't put any part of the appliance in a dishwasher.
F BLADE UNIT
26 You may remove the blade unit for cleaning.
27 This is best done with the jug turned upside down.
28 Grip the jug handle with one hand.
29 Grip the bottom of the blade unit with the other hand.
30 Turn the blade unit anti-clockwise till it comes loose from the jug base.
31 Carefully, pull it up and out of the bottom of the jug.
32 Lift the seal away from the blade unit.
33 Wash the seal and blade unit in warm soapy water, rinse, and air dry.
34 Take great care with the blades – don't handle them directly, use a nylon washing-up brush.
35 Replace the seal round the blade unit.
36 Replace the blade unit in the jug base.
37 Turn the blade unit clockwise to tighten it.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous substances in electrical
and electronic goods, appliances marked with this symbol mustn't be disposed of with
unsorted municipal waste, but recovered, reused, or recycled.
4 motor unit
Y pulse
5 blade unit
6 seal
7 jug
67
8 safety interlock
9 latch
10 tab
11 lid
12 cap

Publicidad

Tabla de contenido
loading

Tabla de contenido