Emptying The Dust Container; Cleaning The Filters - Beko VCM 71605 AP Manual Del Usuario

4 Cleaning and care
4.2 Emptying the dust
container
1. Press the dust container removal button (2) to
remove the dust container (5) and remove the
dust container.
2. Push the dust container removal latches
located at the back of the dust container (5)
from both sides.
• Open the dust container (5) cover and empty
the container.
3. When you have emptied dust, close the dust
container cover (5); a click sound will be heard.
4. Insert the dust container (5) back into its
location.
4.3 Cleaning the cyclone
separator
1. Press the dust container removal button (2) and
remove the dust container.
2. Press the opening button for the motor
protection filter (MIF) housing (8) and open the
cover.
3. Remove the motor protection filter (MIF)
located inside.
10 / EN
4. After removing the motor protection filter,
you will see the metal handle on the cyclone
separator. Holding this handle, remove the
cyclone separator from the dust container (5).
5. Clean the cyclone separator and the dust
container (5) compartment with a soft brush
and wipe them with a damp cloth.
A
WARNING: Cyclone separator
should not be immersed in water.

4.4 Cleaning the filters

Replace your filters at regular intervals according
to the frequency of use. It is recommended that
you replace the filters every 6 months for average
use.
While you empty the dust accumulated in the
dust container to clean the container, you need to
clean the motor protection filter, the foam filter
and HEPA filter as well.
A
WARNING: Do not use appliances
producing hot air such as hair dryer
or heater to dry the filters.
WARNING: Do not install the
filters without completely drying
A
them; otherwise, smell of moisture
may occur during use, water can
leak from the back of the appliance
or the filters may get damaged.
Vacuum Cleaner / User Manual