Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
The replace should be located in an area:
Out of direct sunlight.
Not susceptible to moisture.
Away from uninsulated outside wall.
The replace is heavy and should be assembled near
its desired location.
It is recommended that two people move the
assembled replace to prevent injury.
Do not install the replace on shelves, raised platforms, beds, blankets, pillows etc. Keep combustible materials such as furniture, bedding,
papers, clothes and curtains at least 3 ft. (914 mm) from the replace.
ASSEMBLY INSTRUCTIONS
1. Lay the Fireplace (A) upside down on a padded surface with the underside
accessible. Attach each Leg (B) to the replace by inserting the tab on the top of
each Leg (B) into the corresponding slot on the bottom of the Fireplace (A). Insert
two Screws (C) into predrilled holes and tighten securely for each Leg (B).
2. Turn the replace (A) upright so that it is standing on all four legs. Align the rear
part of the chimney (E) so that it slides under the lip of the disk attached to the
top of replace (A).
TAB
B
A
E
B
C
C
Publicidad
Tabla de contenido
