Technical Data; Gb | Installation Instructions; Intended Use; Safety Advice - Camargue Moderno e clean Instrucciones De Montaje

Tabla de contenido

Publicidad

Technical data

Model:
Voltage:
Power frequency:
Power consumption:
Power consumption (standby): <1 W
Protection method:
Protection class:

GB | Installation instructions

Dear customer, you have purchased a product
of high quality and long service life from our
range. Please read this manual completely before
installation and follow the instructions. Please keep
the manual in a safe place and pass it on to any
subsequent owners. These installation instructions
can also be requested from our customer support
as a PDF file.

Intended use

The shower WC is only suitable for indoor use. The
shower WC can be used for cleaning the anal area
and for external cleaning of the vaginal area. It
is intended exclusively for private use and is not
suitable for commercial use. Only use the shower
WC as described in this operating manual. Any
other use is considered improper and may result
in damage to property or even personal injury. The
manufacturer or dealer does not accept any liability
for damage caused by improper or incorrect use.

Safety advice

HINT:
The following symbol
qualified electrician is required!
DANGER OF ELECTRIC SHOCK! Incorrect
electrical installation or excessive voltage can
lead to an electric shock!
• CAUTION ELECTRIC SHOCK! Before drilling,
Shower toilet
(Moderno e-clean)
92102/2
230 V AC
50 Hz
1250 W
IPX4
I
• Connect the shower WC only if the voltage of the
• Connect the shower WC to a socket outlet only
• CAUTION WATER DAMAGE! Please switch off
• Incorrectly installed shower WCs may cause
• CAUTION WATER DAMAGE! Before drilling,
• Please have the installation carried out by only a
• CAUTION for hot water setting: Risk of scalding!
• Only approved for mains or potable water. Do not
• Only use a cold water supply! Connecting the ap-
• The shower WC is only suitable for use in rooms
• Do not twist the connection hose or tension it!
indicates that a
• Do not operate the shower WC if there is visible
28
make sure that there are no electrical cables in
and around the drilling location!
CAUTION! If the electrical connection is per-
manently installed, work necessary for this and
the connection to the power supply may only be
carried out by a qualified electrician! Repair work
on the electrical system of the shower WC may
only be carried out by a qualified electrician or an
authorised service employee after consultation
with the manufacturer!
socket corresponds to the information provided
on the rating plate.
with at least 25 cm clearance from the ground.
the general water supply before installation.
water damage!
make sure that there are no water mains at and
around the drilling location!
qualified plumber.
use seawater, service water or rain water.
pliance to a hot water supply may cause scalding
and damage to the appliance.
with a temperature above 0 °C. If there is a risk of
frost, interrupt the water supply and empty the
shower WC.
damage or if the power cord or plug is defective.
If the power cord of the shower WC is damaged,
please contact the manufacturer immediately. It
must then be replaced by the manufacturer or
their customer service to avoid any hazards.

Publicidad

Tabla de contenido
loading

Tabla de contenido