Standards; Transport; Characteristics Of The Place Of Installation - Domus DHS-11 Instrucciones Generales Para Instalación

WARNING! Repairs or work carried out by personnel not belonging to the authorised Technical
Service will result in the loss of cover under guarantee.
CAUTION! Fire protection regulations must be strictly observed.
WARNING! Before starting to connect the appliance, check that the installation values match those
given on the appliance specification plate.
All models comply to standard EN ISO 10472 concerning the safety requirements for industrial laundry
machinery.
2006/42/EC Machinery Safety Directive
2006/95/EC Low Voltage
2004/108/EC Electromagnetic Compatibility Directive
For models with a drum capacity of less than 120 dm3 (4.24 cu.ft):
Standards EN 60335-1 and EN 60335-2-7 concerning Electrical appliances.
Standards EN 55014, EN 61000-3-2 and EN 61000-3-3 on Electromagnetic compatibility.
For models with a larger capacity:
Standard EN 60204-1 concerning Electrical appliances.
Standards EN 61000-6-1, EN 61000-6-3 y EN 61000-3-1 on Electromagnetic compatibility.
Only the United Kingdom:
WRAS IRN R160 approval
To be carried out by the installer:
An approved dual retention valve or other equally effective non-return device must be installed on the
connection point between the water supply and the accessory.
When transporting the appliance, the following should be observed:
o
Current regulations and laws
o
Regulations concerning occupational risk prevention
o
Regulations concerning safety during transport
Check the delivery is in good condition prior to receipt.

4. CHARACTERISTICS OF THE PLACE OF INSTALLATION

As established in current legislation, an omnipolar switch must be installed between the appliance and the
mains electricity supply with a minimum distance of 3 mm for each pole between contacts.
The washing machine must be firmly secured on the floor, which will support its weight and the residual force
generated while spinning.
The washing machine must be correctly levelled leaving spaces to make maintenance easier, 0.5 m on the side
and 1 m at the rear.
WARNING! The stopcocks should be close to the appliance in an easily accessible location.
3
KEEP THESE INSTRUCTIONS SAFELY

2. STANDARDS

3. TRANSPORT