Worx WG155E Manual Original página 13

ASSEMbLy
1. ASSEMBLy OF THE SAFETy guArD
(See Fig. A1, A2)
Fix the safety guard to the trimmer head
making sure the sides are located into the
grooves on the trimmer head.
Secure the safety guard onto the trimmer
head with the screw (a) provided.
2. ASSEMBLE OF THE EDgEr wHEEL
(See Fig. B1, B2)
Insert the edger wheel onto grooves of cutting
head. Make sure the groove of the wheel is
locked in the metal plate.
Press the release button (b) on the wheel and
pull out to take off the wheel.
OPERATION INSTRUCTIONS
wArNINg! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
INTENDED uSE
The machine is intended for the cutting of
grass and weeds under bushes, as well as on
slopes and edges that can not be reached with
the lawn mower.
1. BEFOrE uSINg yOur COrDLESS
grASS TrIMMEr
Your battery pack is UNCHARGED and you
must charge once before use.
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
2. CHArgINg yOur BATTEry PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit: The trimmer head no longer
rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
Cordless Lawn Trimmer/Lawn Edge Trimmer EN
down before recharging.
3. TO rEMOVE Or INSTALL BATTEry
PACK (See Fig. C)
Depress the battery release button to
release battery pack from your trimmer.
After recharging, insert the battery pack into
trimmer's battery port. A simple push and
slight pressure will be sufficient.
4. SAFETy ON/OFF SwITCH (See Fig. D)
Your switch is locked off to prevent accidental
starting. Depress lock off button (c) then on/off
switch (d) and release lock off button (c). Your
switch is now on. To switch off, just release the
on/off switch.
wArNINg! The cutting head
continues to rotate after the
trimmer has been switched off; wait until
it has completely stopped then lay down
the tool.
5. ADJuSTMENT OF THE TELESCOPIC
SHAFT (See Fig. E)
Unscrew the lower locking knob (4) in the
direction indicated to unlock.
Adjust the length of the telescopic shaft to the
most comfortable length.
Tighten the lower locking knob.
6. MAIN HANDLE rOTATION (See Fig.
F1, F2)
Holding the lower housing then pull upward
the shaft, then rotate 90 degree clockwise (See
Fig. F1), then release, the shaft will be locked
in position automatically. (See Fig. F2)
7. ADJuSTMENT OF AuxILIAry HANDLE
Pull up the auxiliary handle locking lever (5).
Hold the lever and rotate the auxiliary handle
to the most comfortable and balanced position
(See Fig. G).
Release the lever, your auxiliary handle has
been locked.
8. ADJuSTMENT OF THE TrIMMEr
HEAD ANgLE TO THE SHAFT
Adjust the trimmer head angle downwards,
Put your one foot on the motor house, then
grip the main handle, apply adequate force to
adjust, as shown in Fig H1.
Adjust the trimmer head angle upwards, Put
13 13