Extension Cords; Machines Grounding Instructions - Clarke WASH&RINSE ErgoEX IMAGE 16 I/IX 120V Libro De Instrucciones

GROUNDING INSTRUCTIONS
120 VOLT, 50/60 CYCLE MACHINES
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This product
is equipped with a cord having an equipment-grounding
conductor and grounding plug. The plug must be inserted into
an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
WARNING:
equipment-grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or service person if
you are in doubt as to whether the outlet is properly grounded.
Do not modify the plug provided with the product - if it will not fit
the outlet, have a proper outlet installed by a qualified electrician.
This product is for use on a nominal 120 volt circuit and has a
grounding attachment plug that looks like the plug illustrated in
Fig. 1. Make sure that the product is connected to an outlet
having the same configuration as the plug. No adaptor should
be used with this product.
For maximum protection against electric shock, use a circuit
that is protected by a ground fault circuit interrupter. The green
(or green and yellow) conductor in the cord is the ground wire.
Never connect this wire to any terminal other than the ground
terminal.
WARNING: To prevent possible electric shock, protect
the machine from rain. Keep the machine
in a dry building.
WARNING: To prevent possible electric shock, always
use a 3-wire electrical system connected
to the electrical ground. For maximum
protection against electrical shock, use a
circuit that is protected by a ground fault
circuit interrupter. Consult your electrical
contractor.
WARNING: Do not cut, remove or break the ground pin.
If the outlet does not fit the plug, consult
your electrical contractor.
WARNING: Have worn, cut, or damaged cords and plugs
replaced by an authorized service person.

EXTENSION CORDS

Use only an approved extension cord with three conductors, a
plug with three terminals, and a connector body with three holes.
The machine has a power cord with wire size 14 AWG (AWG
means American Wire Gauge).
WARNING: If you use an extension cord, use an
extension cord with minimum wire size 14
Clarke ®
Operator's Manual (EN) - Image 16 I/IX 120V
Improper connection of the
ENGLISH
Grounded
Outlet
Grounding
Plug
Figure 1
EN
Grounded
Outlet Box
- 5 -