Rowenta DG5030U1 Manual De Instrucciones página 6

Hang the garment on a coat hanger and hold
the fabric from the bottom of the garment
slightly taut with one hand.
Holding the iron in a vertical position, press
continuously on the steam button while
moving the iron from the top of the garment to
C
the bottom ( ).
If unit is left on without steaming for a length
of time, water can condense in the hose and
droplets of water can be seen when you begin
to use the steam station again. For best results
simply aim the iron away from yourself, other
people, animals and clothing and press the
trigger for a few seconds to remove the
condensation and steam begins to fill the
hose.
7 • Filling the boiler while in
use
Caution : Never unscrew the boiler cap while
iron is producing steam and boiler is under
pressure.
Before opening the boiler, ensure that there is
no steam inside. To do this, press the steam
button and keep it pressed until there is no
more steam.
M INTEN NCE ND CLE NING
Before cleaning ensure that the appliance is unplugged and completely cooled down. The iron Before cleaning ensure that the appliance is unplugged and completely cool down.
can be cleaned with a damp cloth and wiped dry. Never use household cleaners, descalers or The iron can be cleaned with a damp cloth and wiped dry. Never use household cleaners,
descalers or solvents. solvents.
9 • Cleaning the soleplate
In normal use a draggy coating may build up
on the soleplate (starch, detergent buildup,
burnt synthetic fibers). This can be easily
removed by using the Rowenta Soleplate
Cleaning Kit or a quality hot iron soleplate
cleaner available at most stores.
To prevent scratching the soleplate, do not iron
over sharp objects (zippers, etc.). Do not place
the iron on rough surfaces, e.g. metal iron
support, which may scratch the soleplate.
lways put the iron with the soleplate down on
the iron rest, never place on its heel.
10 • Rinsing out the
boiler
Do not use descaling agents.
To ensure optimum steam performance, the
boiler must be rinsed out after every 10 uses. If
your tap water is hard increase the frequency.
6
Turn the unit off (see section "Turning On and
Off") and unplug from outlet.
Slowly unscrew the boiler cap. To prevent
overflow during filling, use the water funnel
provided in the packaging. Fill slowly with
water until the red ball reaches the « max »
level. Do not fill water tank past the base of the
boiler cap thread. Be sure that water does not
spill over. If this occurs remove the excess
water.Replace the boiler cap and screw it on
tightly but be careful not to over tighten.
Over tightening can damage the green 0 -ring
Plug back in to electrical outlet.
8 • fter ironing
Turn the unit off. (Consult section "Turning On
and Off").
Unplug the appliance.
Place the iron on the iron rest and allow to
cool completely which will take approximately
1 hour.
Once cold, empty water from the appliance
before storing. We recommend emptying the
boiler when not in use.
Check that the steam station is unplugged and
cold.
Fill the boiler 3/4 full with tap water.
Shake the boiler for a few moments and then
empty it over a sink (
Repeat the process.
Wipe the steam station base regularly with a
damp cloth and wipe dry.
Never hold the steam station under the tap.
Boiler Cap
To ensure a proper seal, please check the
green rubber ring in the safety cap for wear
and tear regularly. If wear is noted, replace
ring. Replacement rings are available
through our main service centers.
D
).