Please read all instructions carefully before assembly, installation and/or use of this product.
5
cross bar
INCORRECT
CAUTION:
• As with any metal equipment it is recommended that you keep the product clean and remove road salt and debris.
• Do not allow harsh chemicals, road salt, or mud to accumulate on the product for an extended period of time.
• Wash the product with mild soap and water only and a non-abrasive cloth.
For questions regarding replacement parts, the compatibility, fitting and/or use of this rack, please call your nearest ROLA™
authorized retail dealer or Cequent Consumer Products Customer Service.
Cequent Consumer Products, Inc.
Solon, OH 44139 USA
Cequent Help Hotline: 1-800-234-6992
Product Name:
Product Code:
Plastic Knob
Basket
Mounting
Bracket
Spacer Block
U-Bolt
CORRECT
cross bar
•
Page 3
Roof Top Carrier Extension
59505
ATTACH MOUNTING CLAMPS
•
Place mounting brackets on top of each
spacer block. The square holes in
brackets must engage the squares on
spacer blocks.
•
Install u-bolts around cross bars and into
slots in mounting brackets.
•
Install plastic knobs onto u-bolts.
•
Tighten all plastic knobs firmly and evenly.
•
Tighten vehicle's cross bars.
•
Make sure installation is secure by pulling
side-to-side and fore and aft on basket.
NOTE: The cargo carrier should not move
on cross bars when plastic knobs are
tightened properly.
WARNING: There must be a minimum of ½"
of threads engaged on u-bolt on all plastic
knobs.
1-1/4" Max.
3-1/4" Max.
Longer loads, such as canoes or kayaks,
MUST be tied down to the front and rear of
vehicle.
www.rolaproducts.com
59505N Rev A 3-7-06
½" Min.