Beninca RR.4WBP Manual Del Usuario página 8

MENU
The operating mode of channel 1 is preset.
The descriptions of the single submenus are shown hereunder:
IMp
MCH1
TG
Time
MCH2
Same operating modes preset for
MCH3
Same operating modes preset for
MCH4
Same operating modes preset for
MENU
With this function enabled, channel 1 switches only if the corresponding key is pressed for longer than 3
seconds.
safe
This function is useful specially to control alarm installations or in cases when accidental activation is to
be averted.
The receiver is supplied with free access to all functions. If necessary, a key code can be created (see key functions),
which will be asked at each access attempt to the radio menu.
MENU
Menu to type in the transmitter codes in memory.
The submenus are described hereunder:
CH1
CH2
CH3
Add
CH4
FIX
key
8
Monostable. The relay activates for 1 sec when the corresponding key is pressed; then the relay
returns to its original status.
Bistable. When the associated key in the transmitter is pressed, the relay activates. It remains in
its new status until the key is pressed again.
Timed. The relay activation time can be preset within a range of 1 to 600 seconds (10 min).
Select the desired activation time between 1 and 600 seconds, then press OK to store the value
into memory.
The key is associated to channel 1. Press, within 5 sec, the transmitter key which is to be
associated to channel 1.
The key is associated to channel 2. Press, within 5 sec, the transmitter key which is to be
associated to channel 2.
The key is associated to channel 3. Press, within 5 sec, the transmitter key which is to be
associated to channel 3.
The key is associated to channel 4. Press, within 5 sec, the transmitter key which is to be
associated to channel 4.
The four keys of a four channel transmitter are automatically associated, each one to the corre-
sponding channel. (Key1:ch1, key2:ch2, key3:ch2 and key4:ch4).
Press, within 5 seconds, any key of a four channel transmitter.
A key code to protect functions of the radio menu is created.
Type a 4-digit number by pressing + and - keys to increase/decrease the number. Keep the key
pressed to accelerate increase/decrease-
To confirm the desired value, press OK.
Important note: take note of the typed-in code and keep it carefully.
PARAMETERS
FUNCTION
MCH1
.
MCH1
.
MCH1
.
LOGICS
FUNCTION
RADIO
FUCTION