Remote Control Initialization/Reprogramming; Operation - Dimplex BFRC-KIT Guia De Instalacion

Operation

Remote Control
The remote control has a range
of approximately 50ft. (15.25m).
It does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one of 2,
187 independent frequencies, in
the factory, to prevent interference
with other units.
Remote Control Initialization/
Reprogramming
Follow these steps for remote
control initialization and if
required, re-initialization:
1. Ensure that power is supplied
through main service panel.
2. Access the manual controls,
(remove the glass doors if
applicable) pull the right hand
steel curtain to the outside of
the unit. (FIGURE 5)
3. Locate manual controls.
4. Move the 3-way switch to
"Remote".
5. Activate the main power
switch, the red Level 1
Indicator Light will flash
(Figure 6-D)
6. Press and hold the On button
on the manual controls
(Figure 6-A) for five (5)
seconds. The Level 1
Indicator Light
will then flash for 10 seconds.
7. Within the 10 seconds
press the ON button located
on the remote control
transmitter. (Figure 7) This
will synchronize the remote
control transmitter and
receiver.
Figure 6
D
.
A B
E F
(Figure 6-D)
C
7