Ego Power+ HTA2000S Manual Del Operador página 7

◾
Check damaged parts before further use of the hedge
trimmer. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mounting, and any
other condition that may affect its operation.
◾
Check the blade and motor mounting bolts at frequent
intervals for proper tightness. Also, visually inspect
blade for damage (e.g., bent, cracked, and worn).
Replace the blade only with a blade from EGO
◾
Replace the blade if it is bent or cracked. An
unbalanced blade causes vibration that could damage
the motor drive unit or cause personal injury.
◾
If the equipment should start to vibrate abnormally,
stop the motor and check immediately for the cause.
Vibration is generally a warning of trouble.
◾
The trimmer shall be used to cut stems less than
26mm thick.
◾
Trim only in daylight or in good artificial light.
◾
Do not use the battery-operated hedge trimmer in rain.
ADDITIONAL WARNINGS
◾
Do not charge the battery pack in rain or in wet
locations.
◾
Use only with battery packs and chargers listed
in fig.A
◾
The battery pack must be removed from the appliance
before it is scrapped.
◾
The battery shall be disposed of safely.
◾
Do not dispose of the battery in a fire. The cells may
explode. Check with local codes for possible special
disposal instructions.
◾
Do not open or mutilate the battery. Released
electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
CAUTION!
The electrolyte is a dilute sulfuric acid
that is harmful to the skin and eyes. It is electrically
conductive and corrosive.
◾
Exercise care in handling batteries in order not
to short the battery with conducting materials
such as rings, bracelets, and keys. The battery or
conductor may overheat and cause burns.
◾
Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition. Be aware of possible hazards
even when the tool is not operating. Take care when
performing maintenance or service.
◾
Remove the battery pack before servicing, cleaning
or removing material from the tool.
◾
Replacement Parts - When servicing, use only
identical EGO replacement parts. Use of any other
accessory or attachment may increase the risk of
injury.
◾
Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
TM . maintained.
◾
Do not wash with a hose; avoid getting water in
motor and electrical connections.
◾
Store the tool in a dry and high or locked location
out of reach of children.
◾
If situations occur that are not covered in this
manual, use care and good judgment. Contact the
EGO Service Center for assistance.
◾
Save these instructions. Refer to them frequently
and use them to instruct others who may use this tool.
If you lend this tool to someone else, also lend these
instructions to them to prevent misuse of the product
and possible injury.
SAVE THESE INSTRUCTIONS
NOTE: SEE YOUR POWER HEAD OPERATOR'S
MANUAL FOR ADDITIONAL SPECIFIC SAFETY RULES.
SPECIFICATIONS
Blade Length
Cutting Capacity
Weight (Without battery pack)
Recommended Operating Temperature
Recommended Storage Temperature
Measured sound power level L
Sound pressure level at
operator's ear L
PA
Guaranteed sound power level L
(measured according to 2000/14/EC)
Front-assist handle
Valuation of
vibration a
h
Rear handle
◾
The above parameters are tested and measured
equipped with power head PH1400E;
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
HEDGE TRIMMER ATTACHMENT — HTA2000S
EN
51 cm
26 mm
2.20 kg
0°C-40°C
-20°C-70°C
92.3 dB(A)
K=2.72 dB(A)
WA
80.4 dB(A)
K=3 dB(A)
95 dB(A)
WA
4.9 m/s
2
K=1.5 m/s
2
6.7 m/s
2
K=1.5 m/s
2
7