Installing/Removing The Battery Pack; General Maintenance - EGO LBX6000 Manual Del Operador

Align the groove and push the tube onto the blower
housing until you hear a "click".
◾
To Remove (Fig. C)
Press the tube-release button and pull the tube out.
ASSEMBLING/REMOVING THE BLOWER ROUND/
FLAT NOZZLE
◾
To Assemble(Fig. D)
Align the groove in the round/flat nozzle with the tube
knob and push the nozzle onto the tube until it snaps
into place.
◾
To Remove(Fig. E)
Press and hold the nozzle-release button to disengage
the latch, then pull the nozzle straight from the blower.

INSTALLING/REMOVING THE BATTERY PACK

NOTE:
For best performance, we recommend use of the
EGO 56V Battery BAX1500 backpack battery.
Charge before first use.
Use only with battery packs and chargers listed
in fig.A.
◾
To Install (Fig. F)
Put on the backpack battery and insert the battery plug
into the blower.
LED FUNCTION AND AIR SPEED LEVEL
AIR SPEED LEVEL
LED1
LEVEL 1
LEVEL 2
LEVEL 3
LEVEL 4
BOOST
MAINTENANCE
WARNING:
When servicing, use only identical
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician.
WARNING:
To avoid serious personal injury, always
remove the battery pack from the product when cleaning
or performing any maintenance.
◾
To Remove (Fig. G)
Pull the battery plug out.
WARNING: Never drag the cord to remove the
battery pack from the blower.
STARTING/STOPPING THE BLOWER (Fig. H)
◾
To Start
Before running the blower, please check and confirm the
lock button is in position "On". If not, push the lock button
to position "On" , otherwise the air-speed trigger can't be
depressed to start the blower.
Depress the air-speed trigger to turn on the blower.
Increased pressure on the trigger results in higher
blowing speed.
To Stop
Release the air-speed trigger to stop the blower.
TO ADJUST THE AIR SPEED
The blower is equipped with an air-speed indicator, indicating
the maximum air speed level. Start the blower to display the
maximum air speed level. A short-press on the boost button
will change the maximum air speed level, while tapping and
holding on the boost button will turn the boost function on.
LED ON THE BLOWER
LED2 LED3 LED4
Flowing water light

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
petrol, petroleum-based products, penetrating oils,
etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
56 VOLT LITHIUM-ION CORDLESS BLOWER — LBX6000
REMARK
Flowing water light:
Level 1 → Level 2 → Level 3 → Level 4
: On : Off
Do not at any time let brake fluids,
EN
9