FIGURE 3
Assembly Instructions:
1.
Attach the 1-1/4" Shank to Support Tube Assembly using (2) 3/8" carriage bolts and (2) 3/8" hex lock nuts (Figure 3).
2.
Install Support Tube Assembly with 1-1/4" Shank the 2" Shank Assembly. Line up the threads in shank with hole in 2" shank
and install the ½" anti-rattle pin. Tighten ½" pin and install clip (Figure 4).
3.
Rotate side tubes to the horizontal position. Lock side tubes in position with bail pins as illustrated. (Figure 5 & 6)
4.
Slide (8) Wheel Cradle assemblies (4 per tube assembly) on side tubes as illustrated. (Figure 6)
5.
Slide (4) Frame Hook assemblies (2 per tube assembly) on center tubes as illustrated. (Figure 6)
LH Wheel Cradle
Support Tube
Assembly
Bail Pin
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Support Tube Assembly
3/8" Carriage Bolt
3/8" Nylon Lock Nut
1-1/4" Shank
Frame Hook - Long
RH Wheel Cradle
FIGURE 5
ITEM: 63138
DESCRIPTION: Q-Slot 4 Bike Rack
FIGURE 4
Side Tube
FIGURE 6
Page 2 of 15
1/2" Anti-Rattle Pin
1/2" Flat Washer
Pin Clip
Frame Hook - Short
Center Tube
RH Wheel Cradle
LH Wheel Cradle
63138N
Printed in China
Rev D 6-29-12