ProctorSilex Commercial 78522 Manual De Instrucciones página 11

STANDARD STUFFER ASSEMBLY INSTRUCTIONS
Electrical Shock Hazard. Disconnect power before assembling.
w WARNING
w WARNING Cut Hazard. To avoid serious or fatal injury, never reach into
grinder feed chute. Always read instructions.
1. Insert the Head into the Gear Housing
with the feed chute of the Head facing
straight up. You will need to line up
the slot in the Head with the Key
inside the Gear Housing. Be sure
the Head is seated fully into the Gear
Housing (FIGURE 6).
2. Tighten the Head-Locking Knob
to lock the Head into place.
3. Insert the Auger, with the Auger
Bearing attached, into the Head
(FIGURE 7). Align the Auger Splines
with the Drive Shaft of the Grinder.
NOTE: Periodically inspect the Auger
Bearing for wear. If the Auger Bearing
has excessive wear, replace it to
prevent head damage.
4. Slide the Stuffing Star over the round
portion of the Auger Pin.
5. Slide one of the Stuffing Funnels
through the Flange and place it
through the Front Ring Nut.
6. Install the Front Ring Nut. DO
NOT OVERTIGHTEN. Turn the Front
Ring Nut until it makes contact with
the Flange; then make 1/4 turn more
to tighten into place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 8).
8. NEVER operate Grinder without the
Tray and Safety Guard secured in
place (FIGURE 8).
Refer to page 7 for Safety Guard
instructions.
Feed
Slot in Head
Chute
Head
Drive Shaft
Gear
Housing
Auger Bearing
Auger Splines
Auger
Auger Pin
Stuffing Star
Stuffing
Funnel
Flange
Front Ring
Nut
Tray
Neck
Feed
Chute
Head
FIGURE 6
Head-Locking
Knob
FIGURE 7
Head
FIGURE 8
11