ProctorSilex Commercial 78522 Manual De Instrucciones página 12

HIGH-SPEED STUFFER ASSEMBLY INSTRUCTIONS
Electrical Shock Hazard. Disconnect power before assembling.
w WARNING
Cut Hazard. To avoid serious or fatal injury, never reach into
w WARNING
grinder feed chute. Always read instructions.
NOTE: The High-Speed Stuffing System
is designed for use with the 10-mm
Funnel ONLY. DO NOT attempt to use
the High-Speed Plastic Auger with any
other Funnels. SERIOUS DAMAGE to
the Grinder Head and other components
may occur. Follow the "Standard Stuffer
Assembly Instructions" located in this
manual, when using the 20-mm, 30-mm, or
40-mm Funnels.
1. Insert the Head into the Gear Housing
with the feed chute of the Head facing
straight up. You will need to line up the
slot in the Head with the Key inside
the Gear Housing. Be sure the Head
is seated fully into the Gear Housing
(FIGURE 9).
2. Tighten the Head-Locking Knob to
lock the Head into place.
3. Insert the Auger, with the Auger
Bearing attached, into the Head
(FIGURE 10). Align the Auger Splines
with the Drive Shaft of the Grinder.
NOTE: Periodically inspect the Auger
Bearing for wear. If the Auger Bearing
has excessive wear, replace it to
prevent head damage.
4. Slide the High-Speed Plastic Auger
onto the Auger Pin, making sure
the square part of the Plastic
Auger fully seats on to the
square portion of the Auger Pin.
5. Slide the 10-mm Stuffing Funnel
through the Flange and place it
through the Front Ring Nut.
6. Install the Front Ring Nut. DO NOT
OVERTIGHTEN. Turn the Front Ring
Nut until it makes contact with the
Flange; then make 1/4 turn more to
tighten into place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 11).
8. NEVER operate Grinder without the
Tray and Safety Guard secured in
place (FIGURE 11).
Refer to page 7 for Safety Guard
instructions.
12
Slot in Head
Feed
Chute
Head
Drive Shaft
Gear
Housing
Auger Bearing
Auger Splines
Auger
Auger Pin
10 mm
High-Speed
Stuffing
Flange
Funnel
Front Ring
Nut
Tray
Neck
Feed
Chute
Head
FIGURE 9
Head-Locking
Knob
FIGURE 10
Head
High-Speed
Plastic Auger
FIGURE 11