ProctorSilex Commercial 78522 Manual De Instrucciones página 8

GRINDER ASSEMBLY INSTRUCTIONS
Electrical Shock Hazard. Disconnect power before assembling.
w WARNING
w WARNING Cut Hazard. To avoid serious or fatal injury, never reach into
grinder feed chute. Always read instructions.
1. Insert the Head into the Gear
Housing with the Feed Chute facing
straight up. You will need to line up
the slot in the Head with the Key
inside the Gear Housing. Be sure
the Head is seated fully into the
Gear Housing (FIGURE 2).
2. Tighten the Head-Locking Knob
to lock the Head into place.
3. Insert the Auger, with the Auger
Bearing attached, into the Head
(FIGURE 3). Align the Auger
Splines with the Drive Shaft of the
Grinder.
NOTE: Periodically inspect the
Auger Bearing for wear. If the
Auger Bearing has excessive wear,
replace it to prevent head damage.
4. Place the Knife onto the square
part of the Auger Pin (FIGURE 3).
Be sure the blades of the Knife
are facing outward.
5. Place one of the Grinder Plates onto
the Auger Pin; align the notch in the
Grinder Plate along with the Pin in
the Grinder Head.
6. Install the front ring nut. DO NOT
OVERTIGHTEN. Turn the front ring
nut until it makes contact with the
grinder plate; then make 1/4 turn
more to tighten into place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 4).
8. NEVER operate Grinder without the
Tray and Safety Guard secured in
place (FIGURE 4).
Refer to page 7 for Safety Guard
instructions.
8
Slot in Head
Feed
Chute
Head
Drive Shaft
Gear
Housing
Auger Splines
Auger
Auger Pin
Knife
Grinder Plate
Front Ring
Nut
Tray
Neck
Feed
Chute
Head
FIGURE 2
Head-Locking
Knob
FIGURE 3
Head
Auger Bearing
NOTE! Be sure the blades
of the Knife are facing out.
FIGURE 4