Hot Air Outlets; Pre-Utilisation Check; Flue Baffle Mounting; Access To The Fans - FRANCO BELGE 634 10 49 Instrucciones De Instalación

"HEKLA" - ref. 634 10 49 & 634 10 50
4
)
1
4
)
3
- Flue - Hearth
1 2
baffle plate
Figure 14 - Flue baffle mounting
3
- Ash-pan
1 2
Figure 15 - Access to the fans
Technical manual "1246"
*
*
4
2
1
- Stop-block
3 4
3
2
1
- 4 screws - Grates
3

2.11. Hot air outlets

In the case of the insert fire being the hearth of a
chimney to be built, it is possible to fit two outlets to
diffuse air to adjacent rooms. In this respect :
- Remove the blanking plates on the casing on top
of the appliance (fig. 13).
- Secure the 5 mm O.D. screws.
- Fit the flue collars supplied by rotating them.
- Use insulated flexible pipe Ø 125 mm.
- Avoid using pipes longer than 6 meters.
- Eventually use hot-air vent controls.

2.12. Pre-utilisation check

- Check that the seals of the smoke-line are in good
condition.
- Check that the door closes correctly.
- Pin
- Check that the glass is not damaged.
- C h e c k t h a t t h e s m o k e pa s s a g e s a r e n o t
obstructed by packaging or removable parts.
- Check that all removable parts are correctly
installed.
Note : if it acts of a ceramics braid, it is consumable
and thus brought to be changed by the user.

2.13. Flue baffle mounting

The baffle plate 1 is laid in the hearth when it
leaves the factory. Install flue baffle (attached on
hearth grate before leaving the plant) inside
combustion chamber (figure 14).
- First slide section A over front dampers then lay
section B on hearth decoration plate 2.
The pins 4 have to be located behind the brackets.

2.14. Access to the fans

Model 634 10 49 only.
Figure 15
Open the main door and to withdraw the ashtray
2
(1), to
remove the 4 screws (2) and to deposit the grids
right-hand side and left (3).
To go up them, proceed in the opposite order.
Regulations of installation
Installation instructions
1
2
Figure 13 -
Hot air
outlets
10