Built to Exceed
3 YEARS
L I M I T E D WA R R A N T Y
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous in
the hands of untrained users.
e)Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may a ect the power tool's operation. If damaged, have the
power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f ) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these instructions,
taking into account the working conditions and the work to be performed. Use of the power
tool for operations di erent from those intended could result in a hazardous situation.
5)
Service
a)Have your power tool serviced by a quali ed repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
Special requirements for rotary hammer
1. Wear ear protectors. Exposure to noise can cause hearing loss.
2. Use auxiliary handles, if supplied with the tool. Loss of control can cause personal injury.
3. Hold Power tool by insulated gripping surfaces, when performing an operation where the
cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a
"live" wire may make exposed metal parts of the power tool "live" and could give the operator
an electric shock.
4. Wear a dust mask. Do not inhale the harmful dusts generated in drilling or chiseling ope
ration. The dust can endanger the health of yourself and bystanders.
5. Before beginning work, check the working area (e.g. with a metal detector) to ensure that no
concealed electric cables or gas and water pipes are present. Contact with electric lines can
lead to re and electric shock. Damaging a gas line can lead to explosion. Penetrating a water
line causes property damage or may cause an electric shock.
6. If the supply cord of this power tool is damaged, it must be replaced by a specially prepared
cord available through the service organization.
7. Do not touch the bit during or immediately after operation. The bit becomes very hot during
operation and could cause serious burns.
8. Do not use the power tool with a damaged cord. Do not touch the damaged cord and pill the
plug from the outlet when the cord is damaged while working. Damaged cords increase the
risk of an electric shock.
4