Prior To Operation; Assembly - Siefken SD4210 Instrucciones De Uso

5. Goose Chisel (Hammering) :18*400mm (SDS max)
6. Surface Roughing (Hammering)
(1) Bushing Tool + (2) Shank
7. Tamping (Hammering)
(1) Rammer + (2) Shank (150 x 150 mm)
Optional accessories are subject to change without notice.

Prior To Operation

1. Power source check
Ensure that the power source to be utilized conforms to the power requirements speci ed on
the product nameplate.
2. Switch status check
Ensure that the power switch is in the OFF position. If the plug is connected to a power recep-
tacle while the power switch is in the ON position, the power tool will start operating immedia-
tely, which could cause a serious accident.
3. Extension cord
When the work area is removed from the power source, use an extension cord of su cient thic-
kness and rated capacity. The extension cord should be kept as short as practicable.

Assembly

1. Install and Removing the SDS-max bit (Fig.1)
CAUTION:
To prevent accidents, make sure to turn the switch o and disconnect to the plug from the
power receptacle.
Warning: Always wear gloves when changing accessories. The exposed may become extre-
mely hot during operation.
NOTE ：
When using tools such as Tine chisel, drill bits, etc., make sure to use the genuine parts desig-
nated by our company.
Built to Exceed 3 YEARS
L I M I T E D WA R R A N T Y
7