VONROC LR501DC Manual Del Usuario página 6

EN
• If desired, multiple colours can be used to
repair a damage.
Tip! Always build up the colour from light to
dark.
• For larger or deep damaged areas, it is recom-
mended to combine the transparent wax (K)
together with the chosen base colour in order
to create a better matching result.
Melting the Wax (Fig. D)
• Turn the device on like mentioned in "switching
the device On/Off".
• Melt a small amount of wax by using the wax
melting tip (2) and transfer to wax to the dam-
aged area.
Risk of burns! Avoid skin contact with the
device and protect yourself from dripping
wax!
Filling the damaged area (Fig. E)
• Fill the damaged area with wax layer by layer
until the area is completely filled with wax.
Make sure there is a slightly excessive amount
of wax used. The redundant wax will be scraped
off, as explain in "finishing and fine matching".
• For vertical surfaces it is advisable to mix the
colour beforehand and apply quickly with the
scrapper.
Finishing and fine matching (Fig. F - H)
• Allow the wax to cool for a few seconds for
small damaged areas.
• The cool down time depends on the size and
depth of the damaged area.
• With light pressure carefully remove excessive
wax with the ribbed side of the flattening scrap-
er (9). Repeat this several times in different
directions.
• Wipe the abrasive sponge (10) over the filled
area to degrease the surface.
When repair of the damaged area is done
always switch off the device and place the
protection cap back on the device.
5. MAINTENANCE
Cleaning (Fig. I)
• The flattening scraper (9) can be cleaned with
the serrated edges of the cleaning scraper (8).
6
• Clean the wax melting point (2). Residue must
be removed.
• Let the melting tip cool before placing the pro-
tection cap back on the device.
NOTICE! Risk of product damage! Never
submerge device in water while cleaning.
Do not use cleaning agents or solvents. Wipe the
device using a dry cloth.
Changing the batteries
• Open the battery compartment (7).
• Place batteries. Pay attention to correct polarity!
• Close battery compartment.
Storage
NOTICE! Risk of product damage!
• Store the product in a dry, well-ventilated place.
• Only store and transport the product in its origi-
nal packaging.
Taking out of operation for a longer period of time
• When not in use for a longer period of time,
remove the batteries.
NOTICE! Risk of product damage! Old, leaky
batteries can damage the product. Check
the battery regularly.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WWW.VONROC.COM