Publicidad
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
Mount the body in such a way, that the outlet
faces to the top and that the marking on the
protective cover is flush with the face of the tiling.
Depth of fitting 55 - 83 mm.
Extension set 28 mm.
Note: When installation is complete ensure
that the mixer is turned off!
The pressures of the cold and hot water
connections must be balanced.
Final assembly
Finish set Sportive
Finish set Talis E
Finish set Metropol
Finish set Mondial
Finish set Metris
Finish set Focus E
Finish set Talis S
Finish set Metris E
Finish set Metris S
Operation
The mixer is activated by pulling the lever
handle.
Move to the left = hot water,move to the right =
cold water.
Test certificate
DVGW
13620180
4
P-IX
SVGW
PA-IX
X
9628-IC
English
Technical Data
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Connections G ½":
Rate of flow:
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
To adjust the hot water limiter on single lever
mixers, please see page 5.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts (see page 3)
1
nut
2
cartridge cpl.
3
seal
4
extension set 28 mm
ACS
cold right - hot left
NF
WRAS
X
X
max. 1 MPa
0,1 – 0,5
1,6 MPa
mac. 80° C
65° C
95007000
92730000
95008000
32698000
KIWA
Publicidad
