Volume/Tone Push Button - Datalogic Magellan 2300HS Guia De Inicio Rapido

Volume/Tone Push Button

The Volume/Tone Push Button
Figure
it is pressed:
NOTE
Table 1. Volume/Tone Push Button Functions
PRESS
DURATION
Momentary (when
scanner is asleep)
Momentary (when
scanner is awake)
Hold, then release
when the beeper
sounds
4 Seconds
8 Seconds
a. By standard default, this function is normally disabled to prevent accidental activation by users.
b. Users should not perform scanner resets except under the direction of trained systems support person-
nel.
Quick Reference Guide
2c) also performs multiple functions depending upon the duration of time
Volume changes made using the Volume/Tone Push Button are
lost when the scanner is powered-down and are reset to the
configured setting. If you wish to permanently change the vol-
ume, use the special programming labels in the Product Refer-
ence Guide.
FUNCTION
Wakes scanner from Sleep
Mode
Increments volume
Increments tone
Scanner Diagnostics Mode
b
Resets Scanner
2d — accessed by removing the Top Cover
(Figure
Alternatively, the scanner can be awakened by:
- Moving an object through the scan zone.
- Scanning with an attached auxiliary scanner.
Press the push button momentarily to increase speaker
volume. When the loudest volume is reached, a repeated
press of the push button cycles volume back to the low-
est setting, then volume increases on subsequent
press(es). Four volume levels are available.
Press the push button for approximately 2 seconds, then
release. Each time this is done, the beeper will sound at
one of three tones. Stop when the desired tone (high,
medium or low) is sounded.
This mode allows system support personnel to trouble-
shoot problems with the scanner and is used to deter-
a
mine if it can read bar codes. Press the button for eight
seconds or cycle power to exit Scanner Diagnostics Mode
and reset the scanner.
Only system support personnel should perform a reset.
COMMENT
3