ASROCK E35LM1 Manual De Instrucciones página 17

2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA3 Connectors
(SATA3_1: see p.2, No. 12)
(SATA3_2: see p.2, No. 10)
(SATA3_3: see p.2, No. 11)
(SATA3_4: see p.2, No. 9)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 19)
(9-pin USB8_9)
(see p.2 No. 18)
Consumer Infrared Module Header
(4-pin CIR1)
(see p.2 No. 17)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 20)
These four Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
Besides four default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
This header can be used to
connect the remote
1
GND
controller receiver.
IRTX
IRRX
ATX+5VSB
This is an interface for front
GND
PRESENCE#
panel audio cable that allows
MIC_RET
OUT_RET
convenient connection and
control of audio devices.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
ASRock E35LM1 Motherboard
17