Fault Finding - Vestfrost SW Serie M Instrucciones Para El Uso

GB

Fault finding

Fault
The control lamp is
not lit.
Water collects on
the glass shelves.
Water collects in the
bottom of the refrig-
erator/freezer.
Vibration or bother-
some noise.
Compressor runs
continuously.
Temperature in
freezer too high.
Temperature in re-
frigerator too high.
Possible cause
Power failure; the fuse is blown;
the appliance is not plugged in
correctly.
Items of food at the back of the
shelves are in contact with the
evaporator, thus causing conden-
sation to run onto the shelf.
The defrost water pipe is
blocked.
The appliance is not level.
The appliance is resting against
other kitchen elements.
Bins, containers or shelves are
not positioned correctly or are
jammed.
Containers or bottles inside the
cabinet are rattling against one
another.
Temperature setting too low.
High room temperature.
Temperature setting too high.
The quantity of fresh items
placed in the freezer at a time is
greater than the capacity of the
appliance.
Temperature setting too high.
Many items have been placed
in the refrigerator section at the
same time.
The door is opened too often.
Remedy
Check that power is connected.
Reset the fuse.
Move the rearmost items for-
wards.
Clean the defrost water channel
and the drain hole on the rear
wall of the cabinet.
Level the appliance using a spirit
level.
Move the appliance away from
the kitchen elements or appli-
ances it is in contact with.
Check movable fittings and ad-
just them if necessary.
Move containers and/or bottles
apart.
Raise the temperature setting.
Ensure adequate ventilation.
Lower the temperature setting.
Wait a few hours and then re-
check the temperature.
Lower the temperature setting.
Distribute items within the cabi-
net to improve air circulation.
Keep door closed.
14