Safety Instructions - BGS technic 8696 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Wheel Stud Repair Tool Set | for Trucks
TOOLS
1
Cutting iron, 7/8" x 11
2
Cutting iron, M18 x 1.5
3
Cutting iron, M20 x 1.5
4
Cutting iron, M22 x 1.5
5
Adaptor for cutting iron,
32 mm hex. drive
INDENDED USE
This tool kit is used to recut wheel bolt threads that are damaged or heavily rusted. This tool kit
contains four split dies for the most common thread sizes on truck wheel studs. Thanks to the split
design, the two halves of the cutting iron can be placed on the undamaged part of the thread (usually
at the bolt end) and rotated over the damaged threaded part.

SAFETY INSTRUCTIONS

Our products are designed for the intended use. We assume no liability for improper use of the
product.
Improper use can lead to property damage and personal injury.
It is the responsibility of the user, the suitability of the tools and information for its use.
Read the instructions carefully before starting work.
Use the tool only to work it is intended for.
Observe the general safety regulations for garages.
Keep your work area tidy and clean. Areas or aisles added increase the risk of injury.
Always use the vehicle lifting points specified by the vehicle manufacturer.
Make sure that the vehicle is sufficiently supported by axle stands or ramps. Secure the wheels
by using stop wedges and make sure the handbrake is activated.
Always wear gloves and goggles, when using this tool set.
Pay attention to a safe and non-slip stand when working with this tool set.
Check the condition of the tool regularly and do not use it if it is damaged.
Make sure the tool is properly mounted.
The tool is not suitable for impact wrenches. Use of impact wrenche can be lead in burst of tool
and the flying tool fragments can lead to damage and injury.
Keep children and unauthorized persons away from the work area.
Do not allow children to play with the tool or its package and keep this tool out of the reach of
children.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 8696
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed

Publicidad

Tabla de contenido
loading

Tabla de contenido