Installation - Schluter BEKOTEC THERM FRS Manual De Instrucciones

Installation

5. Installation
BURNS CAUSED BY HOT FLUID
Water in heating systems is under high pressure and can reach temperatures over 100 °C.
• Make sure the heating water has cooled down before you install the product.
Failure to observe these instructions may cause death, severe injuries or material damage.
5.1 Installation
~ 100 mm
WARNING
1. Mount the threaded pipe clamps and the
angled connection fitting on the fixed-value control station (FRS).
2. If the product is installed in a distributor cabinet, no
angled connection fitting and pipe clamps are needed.
3. Install the product in a distributor cabinet or attach it to the wall.
GB
27