Electric Connection - Schluter BEKOTEC THERM FRS Manual De Instrucciones

Installation
5.4 Install temperature monitor STW
5.5 Connect the pre-wired fixed-value control station (FRS) to the power supply
(or to the control module Schlüter-BEKOTEC-THERM-EBC).
Branch outlet

5.6 Electric connection

ELECTRIC SHOCK
• Make sure that the electric installation method does not bypass the protection against electric shock (protection class, protective insulation).
Failure to observe these instructions may cause death or severe injuries.
ELECTRIC SHOCK CAUSED BY PARTS UNDER VOLTAGE
• Disconnect the power supply prior to starting the work and secure it against inadvertent re-connection.
• Check for potential hazards from electrically conductive objects or media.
Failure to observe these instructions may cause death or severe injuries.
brown or black
blue
green/yellow
Pump
appliances
DANGER
DANGER
1. Attach the safety temperature monitor STW with installation tape
(on the front or back); preferably at the rear in the distributor cabinet.
2. See inside cover for wiring diagram.
GB
31