Uline HOOVER H-7197 Manual Del Usuario página 9

WARNING! To reduce the risk of personal injury,
remove battery before cleaning or servicing.
Any other servicing should be done by an authorized
service representative.
If appliance is not working as it should, has been
dropped, damaged, left outdoors or dropped into
water, contact Uline Customer Service prior to
continuing use.
WHAT DOES IT MEAN WHEN CHARGER LIGHT IS:
• Flashing Green – Battery is charging.
• Solid Green – Battery is fully charged.
• Yellow – Leave battery on charger. It's too hot or
cool to charge.
• Flashing Red – Call Uline Customer Service at
1-800-295-5510.
OPERATING ISSUE
Vacuum won't run.
Bag check indicator has
turned red or vacuum won't
pickup or low suction.
Dust escaping from
vacuum.
Wand is difficult to push or
won't move forward.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 9 OF 27
TROUBLESHOOTING
CAUSES
Battery may not be inserted properly.
Battery may not be charged.
Battery may be too hot/thermal
protector has been activated to
protect from overheating.
There may be internal component
damage.
Filter bag full and/ or clogged.
Filter bag full.
Filter bag not installed correctly.
Hose not installed correctly.
Incorrect floor tool.
1-800-295-5510
uline.com
CHARGING A HOT BATTERY PACK
When using a vacuum continuously, the battery may
become hot. A hot battery may be placed directly on
the charger but charging will not begin until the battery
temperature cools to within an acceptable temperature
range. When a hot battery is placed on the charger, the
yellow LED will remain lit until the battery is cool enough
to begin charging.
CHARGING A COLD BATTERY PACK
A cold battery may be placed directly on the charger
but charging will not begin until the battery temperature
warms to within an acceptable temperature range.
When a cold battery is placed on the charger, the
yellow LED will remain lit until the battery is warm enough
to begin charging.
Make sure the battery is fully seated in
battery cavity.
Check the charge level indicator and
charge the battery if it's too low.
Remove battery and let cool for 30
minutes, replace battery and retry or
replace with second charged battery.
Refer to page 7 (Thermal Protector
Statement).
Call Uline Customer Service at
1-800-255-5510.
Empty filter bag.
Empty filter bag.
Review filter bag removal and
replacement. See page 7.
Review Hose installation. See page 3.
Check that the carpet tool is being
used for carpet and hard floor tool is
being used for hard floors.
Adjust angle of floor tool by tilting up,
making easier to push.
RECOMMENDATIONS
0519 IH-7197